The choice of adhesive
Category：Industry news Publish：2015-02-12 00:00:01 View：1435次
[Back]
Adhesive options
Due to the function of the adhesive is you want a specific strong and durable ceramic tiles pasted on the established grass-roots, so the adhesive of choice will depend on the combination of two bonded materials, as well as the adhesive systems are subject to in its specific service environment load type. Fortunately, our JC/T547-2005 (Crystal ISO13007:2004 1th, part 2) adhesives for ceramic tiles in 19 models embodied the world peers in Exchange for decades in the run-in to these complex combinations of service countermeasures of consensus. For example, the lateral deformation of cement-based adhesives, S1, S2 has been shown to counterbalance the cyclic loads and impact of effective performance.
Good adhesive as thin as possible in principle valid, so ceramic tile adhesive in the application really depends on the thickness of the base and the smoothness of ceramic tiles and ceramic tile size. General requirements of the grass-roots level using 2?m a ruler to measure the tolerance does not exceed 3?mm; ceramic tile thickness should also be less than 10%. This way, the thickness of the adhesive between the 2~6?mm. For example, 2?mm thick adhesive to paste the 50?mm?x?50?mm mosaic. However, if the AI fine extruded ceramic tiles, for example, surface roughness GB the maximum allowable variation is 0.8%. Then, a 800?mm?x?800?mm brick is allowed from the datum plane deviation 9?mm, design 10?mm thickness of the adhesive is not conservative.
Adhesive options
Due to the function of the adhesive is you want a specific strong and durable ceramic tiles pasted on the established grass-roots, so the adhesive of choice will depend on the combination of two bonded materials, as well as the adhesive systems are subject to in its specific service environment load type. Fortunately, our JC/T547-2005 (Crystal ISO13007:2004 1th, part 2) adhesives for ceramic tiles in 19 models embodied the world peers in Exchange for decades in the run-in to these complex combinations of service countermeasures of consensus. For example, the lateral deformation of cement-based adhesives, S1, S2 has been shown to counterbalance the cyclic loads and impact of effective performance.
Typical selection of combination binder of
Combined condition of adhesive? typical grade
Rigid indoors (such as concrete) laying on the ground, high water absorption of stoneware pottery in C1
Rigid indoors (such as reinforced concrete) wall laying, high water absorption of stoneware pottery in C1T
Old ceramic tile surface in the Office laying porcelain tiles with low water absorption C2
In the context of long-term flooding of laying ceramic tile C2
Laying ceramic tiles on the outside wall of reinforced concrete C2TE
Metro station, Elevator vibration loads, such as a strong sense of place to lay ceramic tile C2S1
Lobby, the airport restaurant at the mall a quick refurbishment of large-size ceramic tile floor C2F
Laying ceramic tiles on the Interior light partition Board D2T?, C2TS1
In a stainless steel pool swimming pool tiles laying on R2T
Good adhesive as thin as possible in principle valid, so ceramic tile adhesive in the application really depends on the thickness of the base and the smoothness of ceramic tiles and ceramic tile size. General requirements of the grass-roots level using 2?m a ruler to measure the tolerance does not exceed 3?mm; ceramic tile thickness should also be less than 10%. This way, the thickness of the adhesive between the 2~6?mm. For example, 2?mm thick adhesive to paste the 50?mm?x?50?mm mosaic. However, if the AI fine extruded ceramic tiles, for example, surface roughness GB the maximum allowable variation is 0.8%. Then, a 800?mm?x?800?mm brick is allowed from the datum plane deviation 9?mm, design 10?mm thickness of the adhesive is not conservative.
